|
Clear Finishes from Rockler
|
|
|
 Nordic Oil
Puts a lustrous finish on turnings. Specially formulated mix of pure oils, resins and driers produces a tough, durable finish on highly burnished surfaces such as turned bowls and vases. Non-toxic once dried. May be applied to surfaces that come in to contact with food. Water and abrasion resistant. May be applied with cloth or brush. Available in . . .
|
 Rockler Shellac Kits
Fresh shellac dries faster, permitting the proper application of many thin coats in a short time. It also ensures that you’ll get the rich, handsome finish you want for chairs, cabinets, musical instruments, and other fine projects. Because shellac is non-toxic, it’s an ideal choice for cradles and cribs! Each 2 oz. Rockler Shellac Kit contains 2 o . . .
|
 Rocklers Tung Oil
This Rockler exclusive organic finish is made from 100% pure tung oil, making it one of the safest available. . . .
|
 Butcher Block Oil
Deeply penetrates and protects wood. Easy to apply- just wipe or brush on liberally, let penetrate for 5 minutes and wipe off excess. Available in pints. . . .
|
 Toymakers Finish
Applies easily like an oil finish, yet looks like a varnish. Use on bare or stained wood surfaces. . . .
|
 General Finishes Exterior 450 Varnish
Cleanup: Warm, soapy water.Dry Time: Ready to sand in 1 hour under ideal conditions (70°F, 70% humidity). Cooler temperatures and higher humidity will prolong drying time.Thinning: If necessary, thin with 10-20% water.Application: use a foam brush, paint pad applicator or spray gun.Can be sprayed through compressed air, HVLP, airless or C.A.S. unit . . .
|
 Minwaxreg FastDrying Polyurethane
Instructions for use:Surface must be dry and free of old finishes in poor condition, paint, wax, grease, polish, dirt or other foreign matter. Sand to obtain a smooth uniform surface. Remove all dust with a cloth dampened with mineral spirits. Stir Minwax® Fast-Drying Polyurethane before and during use to eliminate settling on the bottom of the can . . .
|
 Deftreg Waterborne Clear Wood Finish
Lends a deep, rich look to interior wood, furniture, cabinetry, paneling, antiques, wicker and crafts. Works well on rose woods and other exotic hardwoods.Dries to touch in 30 minutes.Apply thin coats to avoid drips and runs.Allow 2 hours dry-time between coats.3 coats recommended.If thinning is needed, use water.Cleanup with soap and water.Allow 8 . . .
|
 Deftreg Clear Wood Finish Aerosol
Dries crystal clear and 5 times faster than oil-based polyurethane and varnish. Finish in your project in just one day!Not recommended for wood floors or exterior use.Requires only 30 minutes dry-time between coats.Dries to touch in 30 minutes and may be handled after an hour.Allow 24 hours before normal use. . . .
|
 Watco Danish Oil Finish
Use only on dry wood from which all previous coatings have been removed.Flood surface using a brush or cloth, applying additional finish to areas that absorb all of the liquid.Allow to penetrate for 30 minutes.Reapply, allowing an additional 15 minutes of penetration.Wipe surface completely dry.Ready for use in 8-10 hours.If a topcoat such as polyu . . .
|
 H Behlen Dry Shellac Flakes
Shellac can be recoated within 15-20 minutes if wiped. Can be recoated within 2 hours if brushed.Dries to touch within minutes.Easy to repair.Environmentally safe.Compatible with most other finishes.Dissolves with 200 proof (less than 5% denaturants) anhydrous denatured alcohol.Note: Shellac that has not been dewaxed may present adhesion problems i . . .
|
 Teak Oil
May be applied over raw, stained, newly stripped, or previously oiled wood surfaces.Use a stiff brush, clean rag or fine, nylon mesh pad.Uniformly “flood” the entire surface.Wait 5-10 minutes. If dry spots occur, reapply to achieve uniform wetness.After 30 minutes set time, wipe and lightly buff with a clean cloth.After 24 hours lightly buff with a . . .
|
 Cabot OilBased Polyurethane
Interior Oil-Based Polyurethane is a traditional polyurethane that protects wood surfaces with a hard and durable finish. For use on most types of wood surfaces.Do not thin.Clean up with mineral spirits.Do not use over sanding sealers, lacquer or shellac.One quart covers 125-160 sq. ft. depending on surface porosity.Dries to touch in 4 hours.Allow . . .
|
 Liberon Finishing Oil
For interior use.1 liter covers 32-39 sq. ft.Apply with a brush or cloth.Allow oil to penetrate up to 10 minutes, and wipe off all excess with a clean cloth before the surface gets sticky.Allow at least 5 hours dry time, then apply more coats as required.For best results, gently rub with Extra Fine Steel Wool between coats.To avoid fire hazards, al . . .
|
 Bulls Eyereg Shellac
Will adhere to glass and ceramic.For best results, thin to a 2 lb. cut (2 parts denatured alcohol, 5 parts shellac).May be tinted by adding up to 1.5 oz. per quart.Apply several thin coats with brush, pad or lint-free wiping cloth.1 quart covers approximately 100-150 sq. ft., depending on porosity.Dries to touch in 30 minutes.Let dry 1 hour before . . .
|
 Boiled Linseed Oil
Can cause spontaneous combustion — dispose of all rags properly.Rub Boiled Linseed Oil into the surface and allow 5 to 10 minutes to penetrate the wood. Remove excess oil with a clean, dry cloth.A small amount of Boiled Linseed Oil may be added to oil-based paint to improve flow, lessen brush drag, and increase the gloss and durability of the paint . . .
|
 Deft SemiGloss Wood Finish Spray
Features:Beautiful protection for interior wood, brass and silver.Self-leveling formula requires no sanding between coats.Dries crystal clear and 5 times faster than oil-based polyurethane and varnish.Fast drying and easy application make one-day finishing possible.Easy to touch up.Directions for use:Not recommended for exterior use or for floors.T . . .
|
 Minwaxreg WipeOn Poly
Dries in 2-3 hours.2-3 coats recommended.Clean up with mineral spirits or paint thinner.Coverage: 125 square feet per quart.Pint.Please note that this item can only be shipped to addresses within the continental United States by UPS Ground only. . . .
|
 Minwaxreg Polycrylicreg Protective Finish
The clarity of Polycrylic protective finish makes it an ideal topcoat over Minwax water-based wood stains and any wood surface, especially light woods like maple, ash and birch.Very little odor.Dries in two hours.Cleans up easily with soap and water.Apply with synthetic bristle brush.For interior wood surfaces only.Non-flammable. . . .
|
 Minwaxreg Tung Oil Finish
Recommended for all interior wood surfaces, including furniture, antiques, woodwork, cabinets, doors and paneling.Can be brushed onto raw wood, or over Minwax Wood Finishes and other Minwax wood stains.Apply with cloth or brush.5-10 minute dry time prior to buffing.Re-coat after 24 hours; 2-3 coats recommended.Clean up with mineral spirits.Covers 1 . . .
|
 Minwaxreg Antique Oil Finish
May be used over wood stains to protect and enhance the beauty of unfinished wood.Allow 5-10 minute dry time prior to buffing.Recoat after 24 hours.Two or three coats recommended.Apply with cloth or brush.Clean up with mineral spirits.Coverage: 125-150 square feet per quart.Quart.Please note that this item can only be shipped to addresses within th . . .
|
 Rockhard8482 Table Top Varnish
Creates an abrasion-resistant, high-gloss finish that offers maximum resistance to water, alcohol, chemicals, detergents and other damaging liquids.“Short oil” varnish contains a lower percentage of oil for maximum hardness.Sets free of dust in four hours.For interior use only.Use Rockhard Reducer (#29838) for thinning.Warning: Vapor harmful. Combu . . .
|
 Zinsser Clear Spray Shellac
Wood that has been finished with shellac looks soft and natural, not plastic-coated.The finish will not yellow or darken with age like polyurethanes, and it’s simple to maintain.Easy clean up with alcohol or ammonia and water.Dries to the touch in just 15 minutes.UV resistant.12 oz. aerosol can. . . .
|
 Liberon Finishing Oil
Enhances the natural color and beauty of wood.Quick drying, low odor and easy to apply with brush or cloth.Shake well before use; ensure the surface is free of hard finishes, clean and dry. Allow the oil to penetrate for up to 10 minutes, then wipe off all excess with a clean cloth. Let dry for a minimum of five hours and apply more coats as requir . . .
|
 Mahoneys FoodSafe Fine Finishes
Put a beautiful food-safe finish on wood utility ware. . . .
|
 General Finishes Gel Topcoat
Just wipe on gel with a clean cloth for a drip proof, run proof and uniform finish. Get professional quality results without brush marks. No sanding needed between coats and no unpleasant smell! Satin sheen increases with the number of coats. Won't fade. Use with General Finishes Gelled Stains for a perfect finish. Covers 200 Square Feet per Quart. . . .
|
 General Finishes Original SealACell Clear
The oils penetrate deep within the wood to highlight the warm natural look, while the urethane ensures a deep hardness.Follow with multiple coats of Arm-R-Seal Urethane topcoat.Seal-A-Cell can be wiped on or applied with a foam brush. . . .
|
 General Finishes ArmRSeal Urethane Topcoat
For simple 2-step finishing, wipe on General Finishes Seal-A-Cell for a lustrous finish. After drying, wipe on or use foam brush to apply Arm-R-Seal for a hard, protective finish.Formulated to be wiped on with a cloth or applied with a foam brush, eliminating drips and sags.Penetrates to provide protection and a natural look. . . .
|
 Rockler WunderCote Finish
WunderCote has a slight amber tint that will appear more like a varnish finish, unlike some water-based polyurethanes that tend to look like a plastic finish. Non-yellowing, hard, durable polyurethane finish is easy to apply. Can be brushed on with foam brushes, applied with sponge-type pad, or simply wipe on with lint-free cotton rag. Fast-drying . . .
|
 Zinsser Bullseyereg SealCoat153
Zinsser Bullseye SealCoat dries to the touch in 10 minutes and is ready to sand/recoat in 40 minutes! Plus it’s compatible with all clear finishes. Easily cleans up with ammonia and water. Available in 1 quart and 1 gallon sizes. Guaranteed Compatible with ALL Finishes Alkyd-modified polyurethane Water-base acrylic polyurethane Catalyzed Finishes . . .
|
 Polyurethane Satin Gel Finish
Fast-drying synthetic oils enhance the beauty of wood furniture, cabinetry and small projects while offering uniform color plus excellent moisture and alcohol resistance. Wipe on. Drip-proof, run-proof and non-fading. Clear satin finish. Interior use only.Recommended by Michael Dresdner, a world-renowned finishing expert with over 30 years of exper . . .
|
